| Ringo539 - 4/15/2025 20:32
Just replaced the giant cast bearing block at the bottom of the post on ours this week.
That was making it lean forward alot!
Also could be the post wear pads worn out.
Do a search on posts from Kmech, he has posted alot of good repair info on kinzes in the past
Thanks for the info. I did check the wear pads and made a very minor adjustment on the front, upper. I can’t see that it made any difference, but it is snug now.
How bad of a job is replacing the bearing block? |
Kinze 3600 running nose low
