|
Central PA | thanks for the help tedbear. i discovered that with the app rate module the only time you can enter parameters and select the flow meter control is in the setup wizard. to change the cal factor, the setup must be deleated and start fresh.
i also found the paint will go off after a 2-3 seconds of no pulses at the flow meter input. must be a minimum requirement, im guessing .5-1 Hz. so for a slow shaft rpm there has to be a sprocket or gear to attain a high enough pulse frequency.
it is unfortunate there is longer support on ag leaders website on the specs or use of the app rate module, even though it still serves a simple purpose.
again thanks for sharing your knowledge on nat. | |
|
AL- help, How do you setup app rate module with flow meter input
