|
Ohio | Hello, in atachment is all necessary firmware to do it step by step.
1) I would recommend you to update till the 13.75 the last one for the best work, the old ones have lots of bugs.
2) It is recomended to do step by step, i will atach them in increasing order, i will atach only the major ones, 6, 10, 11, 12 and 13
3) The driving performance between NAV II and NAV III are the same, just NAV III has output for the third solenoid and it has improved resistance. Just update to the last firmware and using AutoPilot ToolBox (atached also) upload the vdb file from External Vehicle Profiles(atached), check the performance if its not good also From AutoPilot ToolBox you may perform automatic calibration.
4) From my experiecnce TAP parameters does not realy improve any performance, they are used mode for OEM instalation and when you have some extraoridnary cases, i have them, but if you really need them i can send them to you in private.
Also, if you upgrade NAV to the last version you should also update your Monitor to the last version in order to make it work good, also the calibration can be made from monitor.
Attachments
----------------
 v6.0 - AgGPS NavController II Firmware.zip (1094KB - 54 downloads)
v10.01 - AgGPS NavController Firmware.zip (1119KB - 57 downloads)
v11.00 - AgGPS NavController Firmware.zip (1158KB - 50 downloads)
v12.01 - AgGPS NavController Firmware.zip (1218KB - 63 downloads)
v12.50 - AgGPS NavController Firmware.zip (1237KB - 59 downloads)
v13.00 - NavController Firmware.zip (1308KB - 50 downloads)
v13.51 - AgGPS NavController Firmware.zip (1441KB - 57 downloads)
v13.75 - AgGPS NavController Firmware.zip (1456KB - 56 downloads)
PiQ v15.00 External Vehicle Profiles.zip (3265KB - 59 downloads)
v4.50 - Autopilot Toolbox II.zip (19803KB - 48 downloads)
| |
|
nav 2 firmware
