|
East Central, Nebraska | i wouldn't change any wires. i would go in and make sure the valve is set to the valve your using and go into the switchbox menu and make sure that each switch is assigned to the sections you want it control. if this is a new setup i would think its likely just some setting incorrect. also make sure you have a rate entered into the monitor.
also if your testing while not moving you need to shut the autoswath off and put in a manual speed.
i setup a strip till bar last night and wast fighing it. when i turn the hydraulic valve on it would run the drives as fast as it could with no control. ended up i had the type of system configured improperly. i am guessing your dealing with something similar. | |
|
Direct command
