|
North Central Iowa | I considered adding the relays a fair amount and may still do. Ag leader claims that their module can handle 4 of the old tru count electric clutches with dedicated power, which I think are the same as the kinze half width clutches. And I’m only using 2. On some older posts, Kmech indicated that this works fine. Guess I’ll find out.
I did run separate power to the clutch control module direct from the battery, 30 amp fused. It’s ran down the 2nd set of high power wires in the can A implement cable using the black deutsch connectors.
To tedbears original comment about grounding of the clutches, I unhooked the original wires out to the clutches at the center post and put on a Weatherpack to plug into the ag leader CCM cables directly. I also checked out at the clutches to make sure they aren’t grounded at the clutch, apparently some were. This disabled the ability to control the clutches from the kinze switch/fold box, someday may work the wiring to have both work. | |
|
Adding clutch control module to kinze planter with Agleader Incommand
