|
North Central Iowa | So I’ve installed a clutch control module to my kinze planter that already had a PMM configured and planted with last year. Will run the half section electric clutches. My question is, do I have to start from scratch and build a new “planter” equipment configuration? Or can one “add” a module to an existing equipment configuration? And if I have to start with a new configuration, will I be reprogramming all the maxbus sensors to the PMM again? Had a few minutes today and booted it up for the first time with the clutch control modules installed. Seems like the incommand sees the module in diagnostics, but that is about it. Not showing up when picking the current “planter” when starting a planting operation. Not that surprising.
Incommand GO16 if it matters. Thanks. | |
|
Adding clutch control module to kinze planter with Agleader Incommand
