|
| I’m trying to update one boundary in my pro 700, but I can’t get only that one boundary updated. Trying to export from AFS Connect onto pro 700 via USB.
My process has been:
1] delete boundary I want to update from pro 700
2] remove USB from monitor
3] wipe CN1 from USB
4] export updated boundary from AFS Connect onto computer as a zipped CN1 (only exporting the updated boundary, nothing else)
5] extract CN1 onto USB
6] put USB into pro 700 and let it boot up
The problem is, after completing the process above, the only boundary I have show up on the pro 700 is the updated boundary. All other boundaries are gone. Shouldn’t all my boundaries be stored internally on my pro 700 even without a USB plugged into the monitor? To me, it seems all the boundaries are only being stored on the USB since they disappear when I delete the CN1 from my USB. Is it not possible to only delete and replace one boundary, while leaving the others untouched in the pro 700? What am I doing wrong?
Thank you!
| |
|
Pro 700 replacing boundary problem
