Jeffersonville, OH | Luap - 1/31/2025 16:29
Does trimble have something like agleaders knowledge base? I went to their site but couldn’t find anything. I’d like to compare their valve to what I have. I’d like to stick with agleader because this is my planter tractor and I have agleader on the planter.
Yes, but for dealers only.
Ag Leader doesn't show a kit for the Geosteer, so I'm not sure what profile or vehicle it would be set for...possible that one of the SteerCommands could run the valve, but I don't know for sure. That valve doesn't look like anything I've seen, and without knowing how it operates, I wouldn't know what vehicle to tell you to set it for if it would connect to the Valve.
EDIT:
So, just found that the bigger CAT tractors, 65-95 C/D/E use the same valves, AND do offer a Legacy SteerCommand kit....so I suppose you could tell it it's one of those, and steer it like that. Maybe take some extra tuning, but should work if the valve is the same. I have a couple used legacy SteerCommands if you wanted to try it. Not sure what harness it would take, but I believe a Geosteer harness is the same as a SteerCommand if memory serves correctly. One of the module harnesses is at least, the Vehicle side.
I attached the 35/45/55 Paradyme Instructions, and the 65-95 GeoSteer/SteerCommand instructions...do you have that Valve shown in them? Do you also have the gray SA module between the Geosteer and the Valve?
Chris
Edited by c_mayer 1/31/2025 15:57
Attachments
----------------
 602-0214-01-A_INST_CAT CHALLENGER 35,45,55 HYD.pdf (2651KB - 4 downloads)
602-0213-01-A_INST_CAT CHALLENGER 65-95 E-Series HYD.pdf (2929KB - 3 downloads)
|
Agleader Hyd. Steering questions
