|
Upstate New York | I'm looking to see if anyone has an ideas on getting just the potentiometer from an electronic supplier for the hydraulic arm rest control of a case magnum.
I'm guessing just potentiometer is going bad, (finicky controls, in neutral, it might creep into position (only notice when the green icon on the A-pillar says it's active).
Here is the whole piece
47372893R LEVER, CONTROL - https://www.messicks.com/parts/new-holland/47372893r
I was hoping to source just the potentiometer/throttle position sensor? online somewhere, throw it on then calibrate in the A post
Googled, and find a lot that are close, but nothing matches up exactly (and I'm not sure the specs). Wondering if anyone might have any leads or ideas other than the whole piece for $$.
Thanks,
 (20250110_092610 (full).jpg)
 (20250110_092534 (full).jpg)
 (20250110_092542 (full).jpg)
Attachments
----------------
 20250110_092610 (full).jpg (62KB - 1 downloads)
20250110_092534 (full).jpg (121KB - 1 downloads)
20250110_092542 (full).jpg (80KB - 1 downloads)
| |
|
Case Magnum potentiometer
