nc ks | 6030TGUY - 11/22/2024 19:53
Install bushing. Obtain some square key stock and start out with the thickest size you can put in there on top. May have to grind down on one side for snug fit. Keep doing that on around the circle using smaller key stock and grinding down to fit as you go until all space is filled up. Wire weld it together when done more so to the cast than the bushing. Clean slobber out of bushing when done. You got nothing to lose.
I like this idea. After you weld the keystock together on both ends and somewhat tack it to the cast, then drive bushing out and smear some jb weld or the titanium stuff to the bottom of keystock to fill in gaps and re insert bushing and let cure. |
4440 Front axle bushing
