|
Colby, KS | I have a EzGuide 250 and EzSteer in a 7250.
I have a long monitor bar on the right front cornerpost. (CNH has a bolt-on monitor bar that goes on the factory brackets. They have a long one and short one.) The 250 goes on the bar with a RAM mount and arm.
I put the T2 controller on the floor in the right front corner by the fusebox. I put bolts through the floormat from underneath and ran a nut down so they don't spin. Then I set the T2 down over these "studs" and spin nuts down on it. I went this way because I move the T2 back and forth between my tractor and sprayer and wanted it easy to get to. I'd rather have put it under the seat, but it's hard to get to. I have a kid that likes to ride in the tractor, so left side of the seat was out of the question. And the plastic behind the seat in the rear window seems too shaky for it. So I opted for the floormat. | |
|
Monitor Mount in Case IH Magnum 7140/EZ Steer?
