|
| We mounted our T2 controller under the seat with the connectors facing forward. We took the seat out and screwed a plate to the floor (through the rubber mat). The plate had bolts welded to it so we can use wing nuts to quickly remove it to take it to the other tractors.
In the picture, you can see off to the right, we use some inch tubing to make a bar that went from rear post to front post. We used to have planter monitor, Raven, and planter marker box mounted there, but now its just marker box and the EZ 500.
The Insight took the place of the planter monitor and the Raven and I used the angle piece that was on the post to mount my RAM ball up there.
Might modify it a little for this spring, the Insight wobbled a little too much last spring, need to solidify my bracket some.
 (IMG_0598_compressed.JPG)
Attachments
----------------
 IMG_0598_compressed.JPG (23KB - 736 downloads)
| |
|
Monitor Mount in Case IH Magnum 7140/EZ Steer?
