Red River Valley, North Dakota | MO1466 - 9/10/2024 21:23
If you have your 2 set points close to the ground then you do use shift plus resume to raise head to stop acre counting on the turn rows. Are there any other symptoms of a bad controller? No I don't have another to swap out. If a "bad" controller just won't let the tilt function work but everything else works fine, I'll probably just wire the tilt solenoid up to a switch and not spend however much a controller costs.
Did not know that.
That was only symptom of controllers here. Always seemed to go out when hooked on a corn head for whatever reason
Starting to remember it did not require the shift button to run deck plates. It was the simple for /aft function it wouldn’t run when went out. So it was not powering the solenoids at hyd block at top of ladder platform .
So if your for and aft works I would guess this may not be your issue.
|
Case IH 7088 shift function on joystick problems
