|
| Had this issue on our CIH 2162 ( FD 70) getting ready to cut wheat back in June. Tried pouring g oil on the affected sections & it sizzles. Called our Macdon tech, he said it wasn't uncommon - cutter bar was bent down in that area. You could see where they angled down compared to the others. Tech said most likely from hitting a rock and called it a "sledge hammer fix". Son took those guards off & adjusted the cutter bar with a sledge hammer. Cured the problem.
On ours the affected area was right at the hinge to the left of the center belt
Edited by boog 8/1/2024 20:24
| |
|
Macdon fd140 sickles getting REALLY hot
