|
Center Valley Wisconsin | Made the container nuts in the shop here. Pics show the pillow block bearings. The entire windmill is on a inch and a half solid shaft slides down into the pipe and is greasable there's a plastic thrust washer that it sits on and swivels.
The two half rings on top of the pole or nothing more than a lifting point since I'm usually working alone just made it easier to put the whole thing up.
Edited by 4020panther 7/25/2024 08:16
(IMG_20240725_080608943 (full).jpg)
(IMG_20240725_080648309 (full).jpg)
Attachments ---------------- IMG_20240725_080608943 (full).jpg (82KB - 40 downloads) IMG_20240725_080648309 (full).jpg (82KB - 40 downloads)
| |
|