East of Broken Bow | Ford860 - 7/24/2024 17:06
Correct welded 3/4" nut on my gooseneck trailer, after breaking it off twice switched to the drill... just don't break your wrist when the Jack's get fully up..
Use a drill driver, and use the clutch. I do that when drilling metal, start with the clutch set low, and tighten it up so it keeps turning as you drill. I used to chip drill bits pretty often as they would punch through a piece of steel. Hardly happens anymore since I started using the clutch. |
Tired of cranking trailer jacks?
