AgTalk Home
AgTalk Home
Search Forums | Classifieds | Skins | Language
You are logged in as a guest. ( logon | register )

Vibration on JD 469 Silage Special Round Baler
View previous thread :: View next thread
   Forums List -> Machinery TalkMessage format
 
Gearclash
Posted 7/18/2024 13:52 (#10816481 - in reply to #10816088)
Subject: RE: Vibration on JD 469 Silage Special Round Baler


Sioux County, NWIA
ag4life - 7/18/2024 08:09

Is your hitch to PTO shaft measurements correct per the manual? High load PTO applications that measurement is very important for CV shafts


CV joints exist to make the pin hole to shaft end measurement irrelevant.

To the OP. If the vibration goes away when you dump a bale, most likely the CV joint is getting too worn. They don’t last all that long typically.
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete cookies)