|
NW Iowa | To be honest i just don't think its a setting.
I set my minders at 10%
Since it's gradual, something just isn't holding it
The input of the SV is overriding it, but the SV job is to hold that speed, unless your rpms dip,
then it slows the speed till the rpms come back up
it will always try and pull it back to the speed setting if rpms allow
When you change speed with the shuttle or propel handle it kicks the sv out
I'm betting it's in the transmission controller on the side of the transmission.
Unless the shuttle is so subtle that it doesn't kick it out, but slowly pulls it down.
One think i'm curious will it do it in reverse?
| |
|
MT585B gradually slowing down
