|
SE Nebraska | I have a new to me 2510h anhydrous bar. I put a dry box on it off of another machine. I have three section anhydrous control with ag leader monitor and modules. I also have a granular strip till control module for the dry with a hydraulic motor controlling the metering rolls. I would like to control each metering roll separately so I could have two section swath control. Is there a way to use two channels on the strip control module to control two electric motors turning the rolls? It doesn't seem to me like that would work because the left section would apply over the right section if they crossed. Unless there's a way to fake out the monitor with widths that aren't accurate. Other option might be to replace granular module with liquid product control module and use clutches on each end of the metering rolls. Any ideas?
 (17141390949632819757705760228506 (full).jpg)
 (17141391296858779520095775020214 (full).jpg)
Attachments
----------------
 17141390949632819757705760228506 (full).jpg (88KB - 55 downloads)
17141391296858779520095775020214 (full).jpg (135KB - 54 downloads)
| |
|
Ag leader swath control on dry box.
