|
Nebraska | Got one installed. Seems to work fine. At least the remote calibrated. Had problems at first and had to rotate the pot as far counter clockwise as I could before it would calibrate. These have a larger resistance range than the original. Have not tried it on an implement yet but since it calibrated it should work. There is also a micro switch that is moved to the normally open contact when you rotate the stop into motor mode. Had to exercise mine and clean up with contact cleaner to get it to work correctly.
Edited by glfarms 3/22/2024 21:35
 (PXL_20240322_204035831 (full).jpg)
 (PXL_20240322_204204285 (full).jpg)
 (PXL_20240322_213230234 (full).jpg)
 (PXL_20240322_203015353 (full).jpg)
Attachments
----------------
 PXL_20240322_204035831 (full).jpg (244KB - 112 downloads)
PXL_20240322_204204285 (full).jpg (202KB - 112 downloads)
PXL_20240322_213230234 (full).jpg (250KB - 114 downloads)
PXL_20240322_203015353 (full).jpg (245KB - 128 downloads)
| |
|
cnh hydraulic remote
