|
Central Indiana | Wheel position sensors are probably at fault and giving a false reading of actual depth. You could try going through a shank calibration again if you haven’t and checking for a software or firmware update but I doubt it will fix it. We have Truset on a 2330 mulch finisher that controls disc depth and shank depth as well as rolling basket pressure and it doesn’t work right either. Sometimes it will be good for a round or two then for no reason it will just barely go in the ground and you have to rephase everything and do it again to get it to go. It starts off going the right depth then jumps the whole frame up so it’s barely scratching. Had Deere out to look at it and couldn’t get it right so we just unplugged it and run in manual mode. Very disappointed in the expensive technology that is mediocre at best…sorry that’s all the help I have | |
|
Deere 2230LL Field Cultivator with tru set
