|
NE WI | Voron is a build not for a beginner. Plus you have to calibrate it and tune it or it will print poorly. I’ve seen many get 80-90% on a voron build only to sell it as they lost interest.
I don’t have any experience with the newer Creality printers. I did have an Ender 5 and still have an Ender 5 plus. They took as much money as they cost in upgrades to print right.
I have 2 bed slingers. They print ok but needed lots of tweaking. I built these as kits 10 years ago. They are a Mendel max 3 and Mendel Max 2. Company is now defunct.
Cheap printers are hit and miss. You either spend time and money tweaking and fixing or just printing and buying filament
I’m running high temp carbon fiber nylon on the Bambu now.
 (IMG_8011 (full).jpeg)
 (IMG_7087 (full).jpeg)
Attachments
----------------
 IMG_8011 (full).jpeg (132KB - 87 downloads)
IMG_7087 (full).jpeg (106KB - 83 downloads)
| |
|
Best 3D printer under $600?
