|
Osakis, MN | So I'm installing a rate controller with a 2630, Ag Express makes the Hagie cab control interface for a sts but not for a 2100-2101. The STS uses a 12 pin Deutsch to control the boom sections, and a large round AMP for flow meter. 2101 uses a 9 pin AMP. The easiest way I can see to do this cleanly is make a 12 pin Deutsch adapter that needs to y off three ways, 1- solution valves 2- flow meter 3-raven fast valve
Other option looks like using a Ag Express AE 3078 can bypass harness a 37 pin AMP from greenstar to 16 pin raven 460 adapter AE 3171 - and adapt to the monitor plugin. This would require jumping the console switches to allow signal flow-through while in the off position.
The second method seems easiest, basically the only thing I need to do is send the boom signal through in the rocker switch off position and leave them off at all times correct?
What am I overlooking in this system? Will the factory solution pump switch remain the same in the system?
This is a screenshot of the STS 10 Hagie installation of a rate controller, significantly different harnesses.
Edited by tomosakis 1/15/2024 09:36
 (Screenshot_20240115-092613 (full).png)
 (Screenshot_20240115-092713 (full).png)
 (Screenshot_20240115-093433 (full).png)
 (IMG_20230525_163053699 (full).jpg)
Attachments
----------------
 Screenshot_20240115-092613 (full).png (108KB - 102 downloads)
Screenshot_20240115-092713 (full).png (124KB - 129 downloads)
Screenshot_20240115-093433 (full).png (217KB - 130 downloads)
IMG_20230525_163053699 (full).jpg (139KB - 91 downloads)
| |
|
Greenstar rate controller in a Hagie 2101, does this sound right to you
