|
| Good day everyone. I have a John Deere 6530 Premium pre 2008 serial break.
I am busy baling hay and tractor tractor is getting the best of me.
Fault codes 2000.09 and 2003.09 are the only active codes. Can Bus codes.
It will bale for 2 lasp or so and then just stop dead.
It cranks after stopping but diesnt fire. Coolant temp doesnt show up on the screen. Leeve the tractor for an hour and everything is cleared.
2 laps and it stops again.
I have changed most of the Terminating Resistors, the ones I could find. Behind the seat at the fusebox, Under the cab on the transmission, Next to the ECU under the bonnet, In the right bottom console.
I find the one behind the cab or under the RH access step.
I've seen a trend on here where someone had the same issue.
Any help will be greatly appreciated. | |
|
John Deere can bus faults. Shutting tractor down
