|
swmn | I tried converting an older JD7300 over to a newer style insecticide box several years ago. Had to cut out openings for the engagement knobs and make a couple other small modifications. Trouble I ran into was that there was enough bind somewhere to cause the drive sprocket mounting plate to bend.
Probably just my getting the alignment out of whack but... has this been an issue on this style of drive/mounting plate?
 (IMG_3277-s (full).JPG)
 (IMG_3279-s (full).JPG)
 (IMG_3281-s (full).JPG)
Attachments
----------------
 IMG_3277-s (full).JPG (74KB - 695 downloads)
IMG_3279-s (full).JPG (94KB - 670 downloads)
IMG_3281-s (full).JPG (98KB - 691 downloads)
| |
|
|
JD insecticide box, drive sprocket mounting bracket bends
