|
north central Ohio | Thanks for the replys. I circled the plugs with n1-01 and n1-02 and they seem plugged in. The rx and tx quit flashing on the board in the box when you unplug it but only the rx quits flashing on the board on door when unplugged. Is there anyway to check the CAN signal from dryer board to 2000 auto flow box? It shows 47v ac to ground but not sure this is an accurate way to test. Thanks
Edited by pigfarmer82 10/6/2023 13:13
 (IMG_4881 (full).jpeg)
Attachments
----------------
 IMG_4881 (full).jpeg (163KB - 16 downloads)
| |
|
GSI top dry network failed error
