|
SWMN, Buffalo Ridge | Think it’s an ‘09 or 2010. Serial plate is roughed up pretty bad, but think it says HUW8168.
I ended up welding it but it broke through a bolt hole and I’m not very confident it will hold.
I went back to see if I had hit something because I didn’t notice it until I picked up on the end. Found a disc and hub off a ripper I sold 10 years ago about 20 yards from the end.
Also screwed something up on the pot on that end and can’t get it to calibrate. When u adjust a pot do you only use the turnbuckle, or are the slots in the pot mount an adjustment as well? | |
|
Gleaner 8200 backbone broke
