roaming | wodenmike - 9/27/2023 06:42
We have a pro 600 in our 2388. Worked fine last week. Sat outside during rain event. Went back to corn yesterday. No yield data on the screen. Yield and flow show a zero. Bushel counter and weight counter don’t change. Only thing that works is moisture and ground speed. Any thoughts on my problem. TIA
On that machine, the flow sensor gets power from the YMIU (Yield Monitor Interface Unit). I would first check the round connector at the flow sensor on top of the clean grain elevator. Make sure it's clean, dry, etc. It's exposed to weather, so that's a pretty likely source of your problem. If everything looks ok at that connector, then look for a 6-pin square Deutsch connector located behind the RH service door, sort of over the right front tire, and check the same there.
If everything is clean and dry and making good connections, then it could be a bad sensor, bad ground, bad YMIU, bad cabling, etc. But since you said it sat out in a rainstorm, checking for clean and dry connections is the first place I'd start. |
Pro 600 monitor
