|
SE Nebraska | Putting a SCH cutting system on a new to us 630f head. The instructions say that the cutterbar should be straight. We put a new backbone on this head before putting the SCH guards on. But we have 1 fairly noticeable dip on the right/middle side of the head. These pictures are with the hydraflex pressure released. Do we need to try and fix this? Possibly a bent arm under the head? They all look fairly straight.
Thank you!
(KIMG5863 (full).JPG)
(KIMG5862 (full).JPG)
(KIMG5861 (full).JPG)
(KIMG5859 (full).JPG)
Attachments ----------------
KIMG5863 (full).JPG (95KB - 205 downloads)
KIMG5862 (full).JPG (98KB - 192 downloads)
KIMG5861 (full).JPG (100KB - 199 downloads)
KIMG5859 (full).JPG (101KB - 209 downloads)
| |
|