|
| I'm dealing with a couple different Tractors I think are have the same issue. (New Holland T9060 and T9040) Both have the fault code 108 'CAN Sensor OPS Message Timeout' when powered on. I went through Trimble support and ensured the correct vehicle profile was loaded and and found OPS (Operator Presence Switch) not functioning in APtoolbox, but used EST to confirm OPS function was good. I have also replaced the NAV2 and the FM-750 monitor with no improvement.
NAV2 is on 13.57 and FM-750 is on 8.10 for software
Anybody have any more ideas for me to try? | |
|
Trimble Autopilot Fault 108
