|
Alabama | I'm trying to replace a Raven 440 and have my GFX 750 perform rate and section control. I believe I have all the hardware wired correctly - Rate and Section Control Module 75774-01, Raven replacement cable 88644 and a Field IQ to GFX Display cable 111083.
I need some help setting up the software side now. These are settings screens I've inputted so far but I don't know if they are correct. I don't know the pin locations on the Raven cable and how to input those settings. Any help is greatly appreciated.
Edited by JDW2 5/24/2023 00:31
 (IMG_1724 (full).jpg)
 (IMG_1725 (full).jpg)
 (IMG_1726 (full).jpg)
 (IMG_1727 (full).jpg)
 (IMG_1728 (full).jpg)
 (IMG_1729 (full).jpg)
 (IMG_1730 (full).jpg)
 (IMG_1717 (full).jpg)
 (IMG_1718 (full).jpg)
 (IMG_1719 (full).jpg)
 (IMG_1720 (full).jpg)
 (IMG_1721 (full).jpg)
 (IMG_1722 (full).jpg)
 (IMG_1723 (full).jpg)
Attachments
----------------
 IMG_1724 (full).jpg (61KB - 442 downloads)
IMG_1725 (full).jpg (62KB - 433 downloads)
IMG_1726 (full).jpg (74KB - 435 downloads)
IMG_1727 (full).jpg (69KB - 442 downloads)
IMG_1728 (full).jpg (63KB - 437 downloads)
IMG_1729 (full).jpg (62KB - 446 downloads)
IMG_1730 (full).jpg (80KB - 414 downloads)
IMG_1717 (full).jpg (68KB - 420 downloads)
IMG_1718 (full).jpg (92KB - 433 downloads)
IMG_1719 (full).jpg (66KB - 439 downloads)
IMG_1720 (full).jpg (82KB - 431 downloads)
IMG_1721 (full).jpg (68KB - 437 downloads)
IMG_1722 (full).jpg (68KB - 425 downloads)
IMG_1723 (full).jpg (63KB - 466 downloads)
| |
|
Raven 440 Replacement with Field IQ and GFX 750 Setup
