|
| I've had one in a 24 ft drying bin since 1982 and have had real good luck with it. you have too be real fussy setting up the grain flow in so that if it is less than full capacity the flow in is centered. The angle of the legs can be varied on ours but that is a job ,unless the bin is full so we set for about 25% moisture and work around that. Does a very good job spreading fines .. If your sample has a lot of cob pieces or stalk you may have some of the chutes along the side of the legs plugwhich will throw most of the grain out the end. Over all the are a low maintenance good worling spreader. | |
|
Agridry Gravity grain spreader
