|
|
Oregon | Novice guidance question. Building a homemade pickup sprayer that will have mid-mount booms on either side and a center boom mounted behind pickup. Each side boom will be split so five sections total. Looking at going with cr7 with accuboom. Will I be able to set-up these different distances during the configuration? I’m guessing there’s every possible scenario to configure but need to make sure. Thank you. |
|
| |
|
NE Indiana | is the CR7 controlling the product through a RCM or you just painting? I believe you can do it through a RCM, but not with just painting. |
|
| |
|
Oregon | Through a RCM
What’s a better way to get mapping and swath control? This full blown raven system is getting kind of pricey...north of 9k. I have raven flow meter and control with teejet valves.
Edited by habermak 1/28/2021 09:31
|
|
| |
|
NE Indiana | I'm pretty sure that when you set up the RCM it will ask for individual section offsets |
|
| |
|
Nw iowa | Your spending that much buy Ag leader integra much nicer screeen can be had for 3000. Much better than ravens junk guidance. Still plenty of room for whatever else you need |
|
| |
Raven cr7 boom set-up
