|
|
Manitoba | Saw this on here last summer. The post talked about which pins to connect to on the T2. I would like a convenient button somewhere on my right console instead of touching the screen or tap dancing for a foot switch. I think I need a normally open switch that is only momentary. I think there was even a guy on here that was selling cables to accomplish this. Thanks. |
|
| |
|
| If you don't get an answer shoot me an email I will look and see where my foot switch hooks in I don't remember off hand. Should be the same concept. Might also look in the cabling diagrams available on Trimble's website the foot switch should be in there I think.
Edited by fourcubs 1/28/2015 08:54
|
|
| |
|
| Big question: Are you running an autopilot or EZ Steer or EZ Pilot? Pretty sure that they connect in different places for at least an Autopilot or an EZSteer. |
|
| |
|
| On the EZ-Steer controller you need to make a momentary connection to wires 10 & 11 on the middle connection. That's the big 25 pin.
Make sure you adjust your display settings to look for the momentary input to engage the steering. Also, you need to hold the connection for about a 1/2 second before it engages. Just quickly tapping doesn't work. |
|
| |
|
SE Ia | Have you considered the EZ Remote Joystick. I mounted a couple to the right of the scv controls in a couple tractors.
In my tractor with EZ steer on waas I use the right and left arrows frequently to nudge right or left. Often when auto steer is engaged I'll use the joystick to steer through the field.
https://store.trimble.com/OA_HTML/ibeCCtpSctDspRte.jsp?section=72065...
|
|
| |
Adding my own remote engage switch - Trimble 750 & FMX
