|
|
NW Oklahoma | Anyone used this place for bearings and chains? 207kkrb17 bearing for $11.25. It's 35.50 at Deere. |
|
| |
|
small town Iowa.... | $22.99 at Deere.
No wait, no freight
Edited by Little Joe 10/9/2010 21:27
|
|
| |
|
Lenawee Co Michigan | Hmmm. I ran that part number on Deere's website and it says "invalid number." |
|
| |
|
small town Iowa.... | Need to use a partial number.
Comes to part # JD9344 |
|
| |
|
| I bought bearings for an old disk there. Quite a bit cheaper than the dealer. I don't have too many acres on the new bearings yet but they look and work like they're supposed to. No problems. |
|
| |
|
NW Oklahoma | Actually the Deere part number is JD9420. I come up with $35.50 on Deere's web site. Goes in drive shaft on 530 baler. I don't think a JD9344 bearing would work very good on a hex shaft!
Edited by sandhillsam 10/10/2010 17:14
|
|
| |
|
Chebanse, IL..... | Why all the price discrepancies on this (?) JD part #? Is the price different everywhere depending on shipping or availability? |
|
| |
|
NW Oklahoma | Good question Ron. Here is what I come up with on Deeres parts site. How does this compare to else where? Part Details
| |  | | Part Number: | | JD9420 | | Part Price: | | 35.50 USD | | On Hand: | | 7 Check Other Stores | | Description: | | BALL BEARING, |
|
This is from big bearing store. 207KRRB17, HPS103GP3 Special Ag Bearing
SKU: 207KRRB17 This bearing is also known as:
FAFNIR: 207KRRB17
BCA: HPS102GP3
Link-Belt:
NTN:
John Deere: JD9420
DIMENSIONS:
BORE: 1-1/4" Hex
O.D. 2.83" Round
IR Width: .984"
OR Width: .669" |
|
| |
|
Brazilton KS | The Big Bearing Store is usually the first place I look.
I have bearings from there in disks, manure spreaders, grain leg, augers, and who knows what else. |
|
| |
|
| I have used the Big Bearing for several purchases and they have been fine. Definitely lower $'s. Have ordered sprockets, roller chain and bearings. If you don't see something on the web site, call them. They had 100H chain that wasn't on their site. Check out Dalton Hydraulics. I received a catalog from them with a hyd. pump I ordered. Lots of "stuff" there too. Bill |
|
| |
|
Texas/New Mexico Stateline | If you use a lot of bearings the freight is nominal when you order several at at time. Also they offer American made in a lot of sizes. |
|
| |
|
| my jd dealer parts charges 10% above jd suggested price ..... 39.05 |
|
| |
The Big Bearing Store.com
