|
| Hooking up a new to me 2017 cih 4585 airseeder cart to an agleader incommand 1200 and I setup the cart through the setup tab on the incommand and when i try load vehicle/implement through the planting page i get the error that the isobus is mismatched and wont let me enter the planting page. Sections and tool width are correct i also tried seting up a generic iso vs the automaticly loaded caseih device and unchecked the section rate control to no avail. Ive tried all possible setup configurations i can think of and had tech support on the phone for an hour and a half without any progress. Only possible issue i can see is when i go into diagnostics page for CAN B the structure label shows funny looking symbols however the tec didnt think that was an issue.
(20210428_205710 (full).jpg)
(20210428_205756 (full).jpg)
Attachments ---------------- 20210428_205710 (full).jpg (86KB - 197 downloads) 20210428_205756 (full).jpg (79KB - 193 downloads)
| |
|