|
jamestown north dakota | I know this is a longshot. Have ordered Trimble kit 54035-62 to install a Trimble nav III and 2050 monitor in the Subject Line above unit. Per instructions for can connections I am to hook into the connector behind the corner post. There isn't the connection stated in the install. Support from Trimble says the unit has been removed from the supported platform lists. The local MF Dealer contacted their regional support that states this shouldn't be an issue to install the above system. Per Massey the connector I should use is 594A in the right hand fender well. It isn't there. Have removed all paneling on the RH fender well to locate said connection. If you have any insight into how this would connect in or what is needed to run TAP with Nav III/2050 please reply. The other side note is the monitor in the tractor isn't what the install shows for a monitor. Believe this to be the Datatronic 5. | |
|