|
| Got a new 16 row mech drive , with ISOBUS connected to Pro700.
It seems to automatically put in 299.2" in the Pro700 as a hitch length. But is actually 258". So it plants early by approx 4' and it stops planting approx 4' early.
I changed the hitch to center rear axle lenght from 39" to 0" thinking it would help. No difference, then i also changed the beacon to hitch lenght down by 12" as well, no differnce.
It seems like any changes i do, doesnt make a difference...
I spoke to Kinze and they say i cant change the drawbar lenght to the proper lenght. And i cant put negative numbers in the start early and stop late in the Task Controller.
Any ideas?
Any help appreciated.
Thanks | |
|
Pro 700/ Kinze/ task controller.
