Azul, Argentina | I'm trying to clean yields maps collected with a Loup Ceres 8000i yield monitor, but the map data doesn't make sense. This is my raw data, in yield editor.
If you zoom at the data, there is too much variation between near points. So I applied the "Smooth velocity" filter in yield editor, with 0.1 value, and an enormous quantity of points gets removed. The monitor is recording points by distance, so I changed it to 2 seconds interval. Same results, one point with "correct" values, the next one it's way up or down, the next normal, and it goes.
Any ideas? I think that a filter that removes so many points it's not normal.
Edited by jpucheu 1/2/2019 06:12
(p1 (full).jpg)
(p2 (full).jpg)
Attachments ---------------- p1 (full).jpg (148KB - 177 downloads) p2 (full).jpg (97KB - 198 downloads)
|