|
Nwmo | My brother traded planters this year and in the past I have always run agleader hyd drive, pmm, and seed command module on his deere planters. This is a 2012 so it should be iso bus and I'm thinking about leaving the agleader modules off the planter and just trying to setup a planter config using the task controller and jd modules. Has anyone done this? If so what functionality do you gain or lose compared to using the agleader modules?
Right now I'm running a 1990 drill this way and it works pretty good, but a drill is a whole lot simpler than a planter.
Thanks,
Devin | |
|