|
SE Nebraska | Pictures of a coop spreader that I have used. Didn't want to weld or drill on their machine so I made it clamp on. Hook up the drive chain and leave the contact wheel up. Can be installed in about five minutes. I used a micro-trak control valve because I already had a monitor that was vra ready for NH3. . Put the proximity sensor by a sprocket to measure revolutions. Did some math to figure out pounds delivered compared to shaft revolutions and used sprockets and motor size to match. Put a tarp on the truck scale without spinners running to calibrate. Worked perfectly for not much money. Sorry I cant find pictures of the finished product.
Edited by Todd P 1/16/2018 13:53
(IMG_20150119_150817377.jpg)
(IMG_20150129_122023319.jpg)
(IMG_20150129_160634018.jpg)
(IMG_20150205_130257968.jpg)
Attachments ---------------- IMG_20150119_150817377.jpg (63KB - 142 downloads) IMG_20150129_122023319.jpg (74KB - 147 downloads) IMG_20150129_160634018.jpg (70KB - 136 downloads) IMG_20150205_130257968.jpg (58KB - 149 downloads)
| |
|