|
| I'm running field iq on a Wilmar 8100. I tied into the mid tech and KZ components. The flow cal should be 361.9. The water flows good for a few seconds then cuts out because the system says there is not enough flow. When I put a smaller cal number in the flow decreases but system shows higher application. Every time I do my math the cal # should be around that 361.9. But the system shows no flow at that number even though there is. Any ideas what it could be? I'm thinking about just swapping out for a raven flowmeter. | |
|
field iq on Wilmar 8100
