|
| Trying to install a foot switch to remote engage a Trimble Autopilot with a Nav 1 controller. The only directions I have state that the momentary switch must be installed between a pin in PBK1 and a pin PBK2, both said to be on harness part # 43177. I can't find that cable on our setup, an 8400 using an Insight for a display. We have the following harnesses,
48077 Display/Alert
52345 Power
43178 Valve / Sensor
51475 Tees into tractor's armrest
Does anybody have any experince installing a remote engage switch like this on a Nav 1 system? It was alot simpler to install on our new Nav 2 Systems.
Thanks
Brad | |
|