|
NW Ohio | Had a NH Super 1048 for years, just got a NH 1075. The guy I bought it off of said the guy before him that was running it was stacking both 2 string and 3 string bales. On the computer there is a toggle switch with a number 2 and a number 3 on either side, for 2 or 3 string. This hasnt ran 2 string for a few years so i decided to try it with our small square bales yesterday. With all the switches in automatic, when I engage the hydraulics, the first 2 tables and and bale spears start going crazy. Like it is out of sinc or something? How do you check to see if the magnetic sensors are working properly or not for each table? Also, where do you send these computers in to get checked or calibrated? I ran the computer in manual and was able to get my hay field picked up, but would like to figure it out before straw season. When I put the switch to 3 string, the tables seemed to act normal. The computer display seems to act normal also. Any info at all would be appreciated.
Thanks
Edited by burky8520 6/9/2013 07:40
 (IMG952013032995162756.jpg)
Attachments
----------------
 IMG952013032995162756.jpg (68KB - 695 downloads)
| |
|
New Holland 1075 bale wagon questions
