|
SE Nebraska | Lately when I start up my Mid-tech RX 400P the position status shows zeros for lat and lon. Then when I display the bar graph it may show one or two sats but the bars are inverted. My ipaq running sitemate shows that it is getting lat and lon and all the gga and vtg stuff. I accidentally discovered that if I changed the baud rate to something else and then changed it back it would show lat and lon and the bar graph would show several sats and the waas bar and the ipaq was still getting the signal. I guess that I can get it to work but it is annoying.
Has anyone else experienced this? Are there any firmware updates that I should be aware of.
Todd | |
|