|
| Okay, so I finally switched the loader to the proper tractor (after the big blizzard), but the fenders want to contact the loader frames when the wheels are turned even before occillation. I even moved the tread setting to the maximum width (88 inches as shown in the pictures), but the fenders still contact the frames. Tire size is 16.9-28. The book indicates that I can get 42 degrees of steering angle, but the best I could do was 25 degrees. As pictured, the right and left fender are set different for the purpose of trial and error. The left (as seated in the tractor) is set closer to the tire even though it's incorrect by the book. I'm about ready to pull the fenders off of the axle and just forget the whole deal so I can turn the tractor in less than a half acre. I never had this problem with the 2wd tractor. lol.
Does anyone have any ideas? TIA.
 (IMG_1077 (600 x 400).jpg)
 (IMG_1078 (600 x 400).jpg)
 (IMG_1081 (600 x 400).jpg)
 (IMG_1082 (600 x 400).jpg)
 (IMG_1080 (600 x 400).jpg)
Attachments
----------------
 IMG_1077 (600 x 400).jpg (25KB - 158 downloads)
IMG_1078 (600 x 400).jpg (25KB - 149 downloads)
IMG_1081 (600 x 400).jpg (65KB - 150 downloads)
IMG_1082 (600 x 400).jpg (50KB - 134 downloads)
IMG_1080 (600 x 400).jpg (61KB - 156 downloads)
| |
|
7810 and 740 loader MFWD axle tread setting
