|
West Michigan | Have a 2600 and original display(brown) hooked together. Have a none itc globe, starfire I think(is a john deere). On first boot up of 2600 I have gps signal, after I cycle power (key) it loses its signal to the 2600. Brown display keeps signal. Have the latest software version 7.32a and have brown diplay set as primary(what stellar support says to do). So to get the two to share the signal I have to power down the screens then un plug the 2600 so it will reboot(John deere screen with bar that runs across bottom). Then they share it until power is cycled again. Any ideas on how to fix this. Could it be a switched un switched power thing??
Thanks Steve | |
|