|
Wisconsin | I'm installing a Deere rate controller on a 1720 planter to control the 3 hydraulic drive motors. Can I use the existing height switch on the parallel arms, and if so, how are they supposed to be wired? Do I need to make a "Y" adapter so the height switch connects to the original planter harness, as well as the rate controller harness?
Also, where are the section control connections being made to control each drive motor? Does the rate controller section control harness get plugged in out by each hydraulic motor, or is there a place in the factory harness to connect closer to the wedgebox?
Any other advice for setting the rate controller up in the tractor screen such as delay settings?
| |
|