|
| I still live in archaic times where nearly all of my chemicals come in 2.5 gallon jugs, or in totes that I use 5 gallon bucks to measure out and dump into the sprayer. I'm tired of it. with a 1200 gallon tank i'm loading 90+ gallons of product into each load by hand. Gets tiring.
I wanna set up a trailer where I can hook up 3-4 265 gallon totes (roundup, 2-4d, liberty, etc.) to pump into I guess an Eductor tank to measure it all out? So the tote fills the eductor, I'd then use a shutoff valve to cut on and off each tote when the eductor fills, and the suck it into the sprayer with either the sprayer's pump or a pacer pump. And then a water tank to flush it.
Is this a normal setup? If not what do you do? Anything better?
Any affordable premade kits?
I drew up in paint what I'm considering building. See any issues? Should cost more than a few hundred bucks. electronic valves would be the biggest expense if i wanted to get fancy.
I'd have it stationary on level ground. And use the markers on the eductor tank to measure out what comes out of the totes.
Edited by ctenc001 7/5/2022 21:57
 (tote_setup (full).png)
Attachments
----------------
 tote_setup (full).png (25KB - 54 downloads)
| |
|
automatic chemical mixing from bulk products
