|
Southern Minnesota | I switched from a cfx750 to a fm1000 on the planter tractor. With the 750 it exported the gps location of the antenna to the 20/20 and then you put your measurements of the tractor and planter into the 20/20 and everything worked fine. With the 1000 it seems to export the location of the planter to the 20/20. If I have the planter parked right on the edge of the headland the 20/20 thinks I'm fully on the headland then if I start to change my measurements in the trimble to 0 the 20/20 puts me closer to where I should be with every number change ( distance planter is behind tractor to 0 and the 20/20 makes a big jump. Same with tractor measurements) why are the measurements in the trimble 1000 effecting the 20/20 and can I change it so it just sends the location of the antenna or the axle of the tractor instead. I'm running an Ez pilot so no nav unit. I'm exporting from the B port of the fm 1000 | |
|
Looking for a trimble fmx expert
